FDM MASONRY DOOR INSTALLATION INSTRUCTION

-

OPTION 1 The mounting flange will protrude into your fireplace opening 2 to 3 inches and be sized to allow 1/4" space between flange and brick wall of your opening. Measure height where mortar joints are. Drill two holes at that measurement on each of the side flanges. Position door in center and level of firebox opening and drill holes into the mortar joints for attachment, use masonry anchors and drill bit (1/4" anchors will work fine). Holes have to be site drilled buy end user. Be sure fireplace door is level and center in the opening before silicone/mortar it. A high temp silicone or refractory cement caulking can be used to fill any voids between the door frame and your fireplace.

-

OPTION 2 To mortar the door in the fireplace opening you must place, level and center the door in the opening. Then mortar the door in place from the inside of the firebox. Let mortar set overnight before you use the door.

This instruction should only be used as guidance.

(Installation hardware not provided by door manufacturer)

-

NOTE: Be sure the door is level and plumb to ensure proper operation of the doors.

Read also Care, Maintenance and Warranty Information.